Hockley, TX

Ductless Heat Repair: A homeowner’s ductless heat pump was failing to provide consistent comfort. I traced the issue to a defective damper motor responsible for zone control. By replacing the motor and recalibrating the system, I restored effective temperature management, greatly improving the home’s climate control.

Customer stated unit would make a loud noise during heating. Upon inspection of the unit I discovered the contactor to be severely rusted and chattering immensely. Recommended replacing the contactor to which the customer agreed. Once replaced system began heating as intended. The noise is no longer as well. Also informed customers of the dryer vent in the attic that has no exit outside the house and spills into the attic.

Heat Pump Repairs: A heat pump displaying inconsistent behavior prompted a detailed inspection. I found a malfunctioning temperature sensor to be the root cause. Replacing the faulty sensor restored proper temperature regulation, allowing the system to operate efficiently once again. I also advised the client on maintenance tips to extend the system’s lifespan.

Indoor Air Purification System Installation: To help a client address concerns about allergens and pollutants, I installed a high-performance air purification system. This advanced unit was strategically integrated into the home’s HVAC setup to eliminate airborne contaminants. With its seamless operation, the system now provides cleaner, healthier air for the household.

Comprehensive Fall Heating System Tune-Up: In preparation for the cooler season, the client requested a full tune-up for their central heating system. I began by thoroughly cleaning the air filters, inspecting the heat exchanger for any wear or cracks, and ensuring the blower motor was functioning smoothly. Additionally, I adjusted the pilot light and tested the gas pressure to maximize heating efficiency. After completing these steps, I verified that the system was primed to deliver efficient and safe heating as temperatures continued to fall.

Damper motors and board not communicating correctly

Thermostat Repair Service: The client complained of uneven cooling throughout their home. I discovered that the thermostat was improperly placed, leading to inaccurate temperature readings. After relocating and recalibrating the thermostat, the home achieved consistent and balanced cooling.

Diagnosed a faulty contactor not engaging 240v and 24 v. Compressor is making a loud noise .Pressures are unstable jumping up and down.Gave customer options on replacing condenser unit and txv.

Upon inspection I discovered the fan motor to be malfuntioning and only spinning a few times before stopping, confirmed proper voltage, fan motor is also overheating. Called to confirm warranty. Will confirm availability with carrier. Customer has agreed to warranty repair at this time. Replaced condenser fan motor and system is operational at this time, allowed time to pass before verification of refrigerant pressure. Supply temp of 62° and pressures are within the intended range.

Performed tune up on upstairs unit. Checked pressures and components amp draw. Cleaned condenser . System is performing properly.Diagnosed a bad condenser fan motor. Runs a few minutes and stops.Unable to performed tune up . Will contact homeowner tomorrow morning to verify warranty with manufacture.

Diagnosed a clogged drain line. Unclogged drain line and replaced wet switch.Checked delta t .System is performing properly at the moment.

Heating System Tune-up: We arrived to begin a comprehensive heating system tune-up for a valued client. This service included cleaning the system, visually inspecting components, testing vital elements, and lubricating moving parts. This comprehensive tune-up ensures optimal performance, longevity, and reliability for the heating system, promoting comfort during the winter season.

Renewing pro plan membership. Verified everything was working correctly. Checked capacitors, electric components and pressures. Cleaned condenser coils. Slight condensation coming from plenum dripping some water onto sheetrock, sealed the spots I thought it was coming from.

Gave est for ductless split.

Customer complaint condenser fan motor not spinning. When I arrived the system was off. Ran system and unit kicked on. Fan motor is a ecm motor. Ran system for a while and turned it on and off. Checked amp draws. Fan running normal. Signed customer up for maintenance on 2 system house. Performed system maintenance on 2 system house. Inspected evaporator coil and drain line. Checked blower and air flow. Inspected condenser coil. Checked capacitor and contactor. Checked pressures and amp draws. Downstaids system was slightly low on r410a. Added 1 pound of refrigerant to system. Washed condenser. System running normal at this time.

Customer complaint system using alot of electricity. Found low 40+5uf capacitor causing compressor to run hot. Customer gave him ahead on replacing capacitor. No maintenance at this time. Replaced capacitor and ran system. Checked system pressures. Masterbedroom has plenty of airflow. System running normal at this time. Recommend not opening window.